Which device is the example for close excess current protection?

Explanation: A circuit breaker is an automatically operated electrical switch designed to protect an electrical circuit from damage caused by excess current from an overload or short circuit. Its basic function is to interrupt current flow after a fault is detected.

Which device is the example for excess current protection?

Examples of overcurrent protection devices are many: fuses, electromechanical circuit breakers, and solid state power switches. They are utilized in every conceivable electrical system where there is the possibility of overcurrent damage.

Which is the example for coarse excess current protection?

Wires, Joints – Soldering – U.G. Cables

Which is the example for coarse excess current protection.

Which device is used for excess current protection Mcq?

Switchgear and Protection Question & answer

Fuse is a simplest and cheapest device used for interrupting an electrical circuit under the condition of short-circuiting, or excessive overload, current magnitudes.

IT IS INTERESTING:  Your question: Which is more secure ASP or PHP?

Which is the example of chorus excess current protection?

Explanation: Excess Current Prptection which is not operate within 1.5 times the designated load Current of the circuit, which is protects. Devise affording Corse Excess Current Protection includes BS 88 fuses fitted with fuse links marked to indicate a class Q2 or class R fussing factor.

Which device is used for protection?

To ensure the highest security, there are many protection devices available in the market which offers you a total range of protection devices for circuits such as a fuse, circuit breakers, RCCB, gas discharge tubes, thyristors, and more.

Which device is used to open or close an electric circuit?

A switch is used to close or open an electric circuit.

What is cartridge fuse?

A cartridge fuse is a cylinder shaped fuse with either metal caps (ferrules) or blade contact points, at both ends. … Most cartridge fuses are rated for 250 Volt to 600 Volt circuits, dependent on the class of the fuse, and rated for varying amperages as high as 600 amps, again dependent on the specific fuse.

What is fusing factor?

Fusing factor. It is the ratio of minimum fusing current and current rating of the fuse. Minimum fusing current is the minimum value of current due to which fuse melts. The current rating of fuse is the maximum value of current due to which fuse does not get melt.

Which of the following devices may be used for over current or too much current flowing in a circuit?

Summary. An electrical fuse is a device that sacrifices itself to provide over-current protection in an electrical circuit. If too much current flows, the fuse wire rises to a higher temperature and melts, thus opening the circuit, but destroying the fuse.

IT IS INTERESTING:  What does code security mean?

Which device is used to prevent the flow of excess current in the circuit?

Resistor is used to prevent the flow of excess current in a circuit because resistor is a device which opposes the flow of electric charge.

Which devices are used for over voltage protection?

Overvoltage protection devices

  • Arcing horns.
  • Avalanche diode.
  • Gas-filled tube.
  • Lightning rod.
  • Metal-oxide varistor.
  • Spark gap.
  • Transient-voltage-suppression diode.
  • Trisil.

Which electrical quantity affects the heat generated in a conductor?

The heating effect of an electric current depends on three factors: The resistance, R of the conductor. A higher resistance produces more heat. The time, t for which current flows.

Which test is conducted to locate the faults in UG cables?

Murray loop test for location of faults in underground cables. Murray loop test is the most common and accurate method for locating earth faults and short-circuit faults. However, to perform the Murray loop test, it is necessary that a sound (good) cable runs along the faulty cable.